Litokol

Pixel 3D

Professional acetate-curing, stain-resistant silicone sealant for permanently elastic joints — with 3X adhesion that needs no primer.

View DocumentsView Documents

Buy In PersonBuy In Person

Buy OnlineBuy Online

Pixel® 3D is a high-performance, high-tech sealant designed for high-humidity environments and for application to fine materials. Its 3D molecular formulation provides an intelligent, long-lasting stain-resistant barrier developed specifically for bathrooms, shower cubicles, sanitary ware, kitchens, glass surfaces, window frames, doors and joints in porous materials.

A professional, acetate-curing sealant for permanently elastic joints between tile, porcelain stoneware, slabs and mosaics — indoors and out, on floors and walls. It is also suitable for sealing expansion joints under severe operating conditions such as swimming pools and facades.

3X adhesion: formulated for application without any adhesion-promoting primer, it delivers a reliable seal in bathrooms, shower cubicles, sanitary ware, kitchens, glazing, window frames and doors.

3X adhesion — no adhesion-promoting primer required3D molecular formulation for a long-lasting stain-resistant barrierSeals expansion joints in severe conditions, including pools and facadesReady to use and reusable, minimizing material wasteFree from solvents and isocyanatesNot hazardous to applicators under the CLP RegulationVery low VOC emissions

Product Details

Suitable Surfaces: Ceramic, Glass, Mosaic, Outdoor / Exterior, Pool & Wet Areas, Porcelain
Coverage: One 300 ml cartridge yields approx. 33 linear ft (10 m) at a 6 × 5 mm joint, or approx. 20 linear ft (6 m) at 8 × 7 mm
Working Time: Tool the joint within the sealant's open time, before a skin forms (approx. 15 minutes)
Cure Time: Skins in approx. 15 minutes; full cure 24 hours at 2–3 mm; foot traffic after 24 hours and full set-up after 5 days at 73°F (23°C)
Available Sizes: 300 ml cartridge (second-life recycled plastic)
Certifications: EN 15651-1 INT-EXT CC
EN 15651-2 G CC
EN 15651-3 S
ISO 11600 F 25 LM
ASTM C920 Class 25
EC1 Plus GEV EMICODE
A+ indoor air emissions
Application Notes: Acetate (acetic) cure — ensure good ventilation during curing, as small amounts of acetic acid are released. Apply between 41°F and 104°F (+5°C to +40°C); 59–77°F (15–25°C) is recommended. Cure time is proportional to joint thickness. Do not use in contact with marble or natural stone. Avoid contact with bituminous materials and plasticizers such as butyl, EPDM, neoprene, bituminous membranes and insulation. When renewing joints affected by mold, remove the existing sealant completely. The product cannot be painted over. Professional use only.